Adjusting the room temperature setpoint
Adjusting the nominal DHW setpoint
Displaying information
Exception
Chimney sweep function
Siemens
Building Technologies
Press the + / - buttons to increase or decrease the Comfort setpoint
.
For the Reduced setpoint
-
Press OK
-
Select the operating line for the "Reduced setpoint"
After each readjustment, wait at least 2 hours, allowing the room temperature to adapt.
Press the + / - buttons to increase or decrease the nominal DHW
setpoint.
Various data can be displayed by pressing the info button.
The display alternates, showing the value and the info no.
-
No. 1 Boiler temperature
-
No. 2 Outside temperature (OT)
-
No. 3 DHW temperature
-
No. 4 Flow temperature 1
-
No. 5 Flow temperature 2
In exceptional cases, the basic display shows one of the following symbols:
Error messages
If this symbol appears, an error in the
plant has occurred. The display shows
letter "c", followed by the error no.
1
To start the chimney sweep function , press the button for a moment (< 3 seconds).
This function produces the operating state required to make emission measurements
(flue gas).
User Manual
AVS37.390
↔
-
No. 10
-
No. 11
-
No. 12
-
No. 13
-
No. 14
Maintenance or special operation
If this symbol appears, a maintenance
alarm is delivered or the plant has
changed to special mode. The display
shows letter "c", followed by the message
no.
1
+
OK
+
State of heating circuit 1
State of heating circuit 2
State of DHW
State of boiler
State of solar
55/138
CE1U2353en
2014-07-30