Ultium Motion Hardware User Manual
5.4 Hardware Setup Instructions
Step 1
Insert the USB-B (smaller) end of the USB cable
(CBL2) into the USB connector on the rear of the
Ultium Receiver (880).
Insert the opposite end of the USB cable into an
available USB port on the computer.
Step 2
Insert the IMU sensor into the Ultium Sensor
Charger (873).
Step 3
Insert the power supply (PSU1) barrel connector
into the associated receptacle on the Ultium
Receiver.
Step 4
Connect the Receiver to the Ultium Sensor
Charger (873). This will charge the sensors
(Rev B)
15