Hardware Installation - Noraxon ultium EMG Quick Start Manual

Insole Smart Lead Quick Start Guide

2 Hardware Installation

2.1 Hardware Setup Instructions
Step 1
Insert the USB-B (smaller) end of the USB
cable (CBL2) into the USB connector on the
rear of the Ultium Receiver (880).
Insert the opposite end of the USB cable into
an available USB port on the computer.
Step 2
Insert the EMG probes into the Sensor Docking
Station (883).
Step 3
Insert the power supply (PSU1) barrel
connector into the jack of the Ultium Receiver.
Step 4
Connect the Receiver to the Sensor Docking
Station (883). This will charge the sensors
(Rev A)
3