Related Manuals for Noraxon myoMOTION System
Summary of Contents for Noraxon myoMOTION System
- Page 1 Quick Start Guide myoMOTION System Quick Start Guide Quick Start Guide Quick Start Guide Quick Start Guide (Rev B)
- Page 2 This is not meant to be a complete manual, but a guide to help you get started with your system. For more detailed instructions on operating the myoMOTION System and its features please refer to the complete myoMOTION Users Manual (P-6808), also included with your system.
-
Page 3: Install The Hardware
myoMOTION Quick Start Guide 2 Install the Hardware Step 1 – Research Receiver Screw on the antenna (ANT3) to the antenna connector located on the rear of the myoMOTION Receiver (680). If the antenna is already attached, check that it is securely tightened. -
Page 4: Configuring The Hardware
4 Configuring the Hardware Before the myoMOTION system can be used, the device software settings must be configured to recognize the different components that make up the system. Follow the below instructions to update the receiver firmware, sensor firmware, and populate sensors to prepare for a data collection. -
Page 5: Attaching The Sensors
“A” will work. However, if using multiple myoMOTION systems, each system must be placed on separate networks to avoid interference that may cause data loss or other issues. If using MyoSync, check the Use Noraxon MyoSync checkbox. Check Accel. Data Accel. Data Accel. - Page 6 Upper foot, slightly below the ankle 5.2 Sensor Placement Orientation Sensors must be placed so the Noraxon logo is facing away from the subject. The positive x-coordinate on the sensor label should have a superior orientation (i.e. up to the sky/ceiling) for the ...
-
Page 7: Recording A Measurement
myoMOTION Quick Start Guide 6 Recording a Measurement Step 1 Within the Home Home screen click the myoMOTION module Home Home icon. Create a New Subject. New Subject. New Subject. New Subject. Note: Defining the height for the subject is important since the software uses subject height in its algorithm to compute bone lengths and create an accurate avatar while recording and later viewing a record... -
Page 8: Viewing A Record
myoMOTION Quick Start Guide Step 5 Select Calibration. Calibration. Monitor the subject to confirm the Calibration. Calibration. calibration position was held for 20 seconds after clicking Calibration Calibration Calibration Calibration. Step 6 After performing your calibrations and selecting a correction mode (if desired), select Record Record.