Noraxon Ultium Motion Hardware User Manual page 32

Ultium Motion Hardware User Manual
Step 3
Select Edit configuration.
Once inserted into the hardware
configuration, the object sensors will
appear available in the software
configuration under the sensors tab: object
sensors.
Step 4
Under the Object sensors section there are
5 tabs. Adjust the information in each
column as needed for the measurement.
Step 5
Once object sensors have been enabled,
they will appear as cubes in the screen with
the avatar. As the object moves, the
illustrative cube will rotate in accordance
with the object sensor's movements. The
data for the curves will be displayed in the
acceleration or orientation angles tabs.
At this point, the object sensors are ready
for recording.
(Rev B)
On (checkbox) – enables the sensor to be
displayed/measured
Name – the name of the object sensor, may be changed
to anything you would like
Base – object sensors are anchored/linked to a body
segment in the biomechanical model
The base sensor selected must be an enabled body
segment in the measurement.
Placement - position of the object sensor in relation to
the base sensor (left, right, front, back)
Distance (mm) – the distance between the object sensor
and the base sensor, this will also change the distance
between the object and skeletal avatar in the display.
32