Table of Contents
Advertisement
Ultium Motion Hardware User Manual
6.10 Record Signal as Desired
After performing the calibration and selecting a
correction mode (if desired), select Record.
Record your signal based on predetermined
protocols. After performing desired movements
in the record, select Stop.
Save the recording to the database and type in a
desired name, then select Discard & Measure
Again or Save & Measure Again to return to the
measurement screen or select Save & View to
visualize the recording.
6.11 Shutdown After Use
At the end of the day:
•
Place all Ultium Motion sensors inside the sensor docking station(s).
•
Apply AC wall power to the docking station (via PSU1 connected to the Ultium Receiver).
•
Push the Sensor Power Button on the Receiver to power all sensors off.
Note: It is necessary to have the Ultium Receiver connected to the PC via USB cable to utilize the
Sensor Power Button.
6.12 Storage & Protection Between Use
For extended storage or when travelling:
•
Place all sensors into the sensor docking station and power them off.
•
Position all components inside the system travelling case according to their prepared cavities.
•
Every 3 months fully charge the sensors once and then normal storage without connection to
power may resume.
Note: It is necessary to charge the sensors once every 3 months. The Litium Ion batteries will expand if
left discharged for too long.
(Rev B)
27
Advertisement
Table of Contents
