Battery Replacement - Noraxon Ultium Motion Hardware User Manual

Hide thumbs Also See for Ultium Motion:
Table of Contents

Advertisement

Ultium Motion Hardware User Manual

8.8 Battery Replacement

8.8.1 Battery Life Expectations
The Lithium Polymer battery used in the Ultium Motion Sensors is rated for a minimum of 300 charge-
discharge cycles. Typical usage is 500 charge-discharge cycles. As the number of charge-discharge
cycles increases the battery capacity slowly declines thereby reducing run time despite being fully
charged.
Brand new batteries can operate up to 8 hours when fully charged. If the run time of the sensors drops
to 5-6 hours, battery replacement should be considered.
8.8.2 Battery Replacement Procedures
The Ultium Motion Sensor batteries may not be replaced by the user. Only
qualified Noraxon technical personnel may perform maintenance.
ATTENTION
Battery replacement service can be initiated by visiting the Support section at Noraxon.com.
(Rev B)
40

Advertisement

Table of Contents
loading

Table of Contents