Table of Contents
Advertisement
Ultium Motion Hardware User Manual
6.8 Checking Signal Quality
Check the signal quality by having the subject move around
(e.g. walk, squat, raise arms, etc.), then confirm the joint
angles, avatar display, and accelerations are appropriate for
the subject's motion.
6.9 Correcting for Magnetic Interference
Magnetic interference is shown as a red sensor on the skeletal
avatar. If you have already determined a clean calibration
location and have training on proper calibration, you may use
one of the correction modes to correct for magnetic
interference.
There are several correction modes available to reduce magnetic interference in recordings.
(Rev B)
25
Advertisement
Table of Contents
