Table of Contents
Advertisement
Ultium Motion Hardware User Manual
Step 4
Click the Sensors Tab.
Place all Ultium Sensors into the chargers and
attach the chargers to the Ultium Receiver.
Select Detect Sensors in Charger to load all
serial numbers into the MR3 software.
Step 5
After detection is complete, click Yes to replace
all existing sensor serial numbers associated
with this device.
Step 6
Assign sensors to body segments by selecting
the dropdown and choosing the location from
the pop-up menu.
Note: Segments already assigned to a sensor
will display a green indicator next to the
segment name.
Step 7
Select OK (in the bottom of the dialog box) to
save the hardware settings.
Note: Sensor serial numbers appear in the order
that they are placed in the charging doc, starting
at the end with the LEDs (opposite of the
charging port).
(Rev B)
18
Advertisement
Table of Contents
