Setting The Feed Mode - Avery Dennison Monarch 9419 Administrator's Manual

S e t t i n g t h e F e e d M o d e
Set the feed mode based on your application and supply type. The default is batch mode.
Select To
None Tear off each label after printing.
Batch Mode Tear off the print job after printing (tear off in strips).
Cutter Batch Cut each label.
Cutter Mode Cut the print job (cuts in strips).
Peeler Mode Separate the label from the liner when it prints (label supply must
be loaded for peel mode).
S e t t i n g t h e C u t P o s i t i o n
This function adjusts where the tag is cut. The printer adjusts the cut position according
to the index marks on the supply. The default is 0 dots.
Select
Navigation
button:  or 
Navigation
button:  or 
S e t t i n g t h e S u p p l y P o s i t i o n
This function adjusts the position of the supply relative to the index marks in the feed
direction. Adjust the supply position to compensate for supply variation. The
adjustments are in dots where one dot equals 0.0049 inch. The default is 0 dots.
Select
Navigation
button:  or 
Navigation
button:  or 
To
Selects positive or negative and which position to change.
Increase or decrease the cut position.
To
Selects positive or negative and which position to change
Increase or decrease the supply position to move the print up or down
Configuring the Printer 2-3