Master Reset; System Flags; Ecr Application Mode; Printing On Journal - ELCOM EURO-2500 Service Manual

© Elcom s. r. o.
1. Print char set
2. Prn.head test
3. Paper sensor
4. Cutter
1. Full cut
2. Partial cut
962. Display tests
1. Connection
2. Complex test
3. Backlight
963. Keyboard tests
1. Communication
2. Key test
964. Ser.comm.tests
1. Comm.port 1
2. Comm.port 2
3. Comm.port 3
4. Comm.port 4
5. Comm.port 5
6. Break signal test

5.3 Master Reset

ECR Master Reset clears the whole data area in the ECR soft-
ware and sets the default values. It is recommended to back-
up the ECR data before performing the Master Reset.
1. Look up "SW Master Reset" in the service mode menu or
enter the code 990 and press O
will ask the confirmation of Master Reset. Pick "Yes" or
"No" and press O E
K NTER
900.Service mode
990.SW Master Reset
Are you sure?
No
5.4 System flags 5.4 System flags
Look up "System flags" in the service mode menu or enter
the code 910 and press O
900.Service mode

910.System Flags

5.4.1 ECR application mode

5.4.1 ECR application mode
1. Look up "Application mode" in the system flags submenu
or enter the code 1 and press O
910.System Flags
1.Application mode
Euro 2500
TX
E E
(N
K NTER UM
(N E ).
UM NTER
<
>
E E
(N ).
K NTER UM NTER
|
E (N E
K NTER UM NTER
|
965. Other tests
1. Real time circuit
2. Buzzer
3. Drawer
4. Jumpers
5. RFID
6. Checksum
7. SRAM memory test
966. FM tests
1. FM tests
2. Serial FM
3. Write test
4. Read test
970. FM Integr. Test
1. Used FM area
2. Whole FM area
3. Clear FM area
990. SW Master Reset
Note: All the external printer submenus are identical with
the KITCHEN printer submenu.
The ECR should be turned off and on again after the Mas-
ter Reset. ECR is then set to the default values. After the ECR
is turned on, you have to select the application mode (see
chapter 5.4.1 for details), enter the date in "ddmmyy" format
and time in "hhmmss" format. Log in using the default pass-
). ECR word.
NTER
Note: There are two default cashiers defined in the ECR; the
password of the first one is "1", the second's is "2". Both of them
have got all privileges and rights to perform all operations.
2. Current ECR mode is displayed. The menu item is purely
informative since ECR mode is set after the Master Reset.
1.Application mode

5.4.2. Printing on journal

5.4.2. Printing on journal
1. Look up "Print on journal" in the system flags submenu or
). enter the code 2 and press O
910.System Flags
2.Print on journal
Service manual
Restaurant
E (N E ).
K NTER UM NTER
|
51