Interface Selection; Configuring The Interface - Datalogic QuickScan QD2590 Product Reference Manual

INTERFACE SELECTION

Upon completing the physical connection between the reader and its host, proceed
directly to "
the interface type the reader is connected to (for example: RS-232, Keyboard
Wedge,USB, etc.) and scan the appropriate bar code in that section to select your sys-
tem's correct interface type.
The reader, depending upon the model, will support one of the following sets of host
interfaces:
•
•
•
•
•
•
•
•
•

CONFIGURING THE INTERFACE

Scan the programming bar code from the following section which selects the appropri-
ate interface type to match the system the reader will be connected to. Next, proceed to
the corresponding chapter in this manual (also listed in the table) to configure any
desired settings and features associated with that interface.
Configuring the Interface" on page 11
USB (Keyboard, COM, OEM)
USB Composite (Keyboard + COM)
USB HID POS
USB Toshiba TEC
RS-232 STD
RS-232 WN
RS232 OPOS
Keyboard WedgeIBM46XX port 9b (a specific cable is required)
Datalogic Magellan
Scanner
NOTE: Unlike some other programming features and options, interface
selections require that you scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to scanning an interface selection
bar code. Some interfaces require the reader to start in the disabled state
when powered up. If additional reader configuration is desired while in this
state, pull the trigger and hold for 5 seconds. The reader will change to a
state that allows programming with bar codes.
for information and programming for
s' specific interface
INTERFACE SELECTION
PRODUCT REFERENCE GUIDE
11