Set Length 2 - Datalogic QuickScan QD2590 Product Reference Manual

REFERENCES

Set Length 2

This feature specifies one of the bar code lengths for a given symbology. Length 2 is the
maximum label length if in Variable Length Mode, or the second fixed length if in Fixed
Length Mode.
Reference the
ber of characters) for the symbology being set. A setting of 00 specifies to ignore this
length (only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length. Pad the number with leading zeroes to
2. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
3. Scan the "Select Length 2 Setting" for the symbology being set.
4. Scan the appropriate two digits from the keypad in
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the following table for examples of how to set this
feature.
Table 20 Length 2 Setting Examples
STEP
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT LENGTH 2 SETTING
Scan two characters from
4
Appendix D
5 Scan ENTER/EXIT PROGRAMMING MODE
250
QUICKSCAN™ QD2590
1D Symbologies, starting on page 103
yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
length setting which was determined in the steps above. You will hear a two-beep
indication after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION
to view the selectable range (num-
EXAMPLES
00 (ignore
07 Character 52 Character 74 Character
second length)
'0' and '0' '0' and '7'
, that represent the
Appendix D
'5' and '2' '7' AND '4'