Stand Mode/Object Detection Illumination Off Time; Corded Stand Mode - Datalogic QuickScan QD2590 Product Reference Manual

SCANNING FEATURES

Stand Mode/Object Detection Illumination Off Time

Specifies the amount of time reader illumination stays off after pulling the trigger when
in Stand Mode/Object Detection. The configurable range is 01 to 32 by 01 in increments
of 500ms (500ms to 16 seconds).
Set Illumination OFF Time
$CSNTM
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

Corded Stand Mode

This parameter sets the Stand Mode operation for corded models only.
$CSMVS00
Corded Stand Mode = Generic Stand
$CSMVS02
Corded Stand Mode = Precise Stand
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric charac-
ters in
desired character(s). End by scanning the ENTER/
EXIT bar code.

04 = Illumination OFF Time 1 second
ENTER/EXIT PROGRAMMING MODE
Appendix D, Keypad representing your
CANCEL

Corded Stand Mode = Disable
$CSMVS01
Corded Stand Mode = Permanent Stand
$CSMVS03
PRODUCT REFERENCE GUIDE
85