Rs-232/Usb Com Parameters; Intercharacter Delay - Datalogic QuickScan QD2590 Product Reference Manual

RS-232/USB COM PARAMETERS

Intercharacter Delay

This parameter specifies the intercharacter delay between the end of one character and
the beginning of the next. The delay can be set within a range of zero (0) to 990 millisec-
onds in 10ms increments. A setting of zero specifies no delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
4. Go to
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
This completes the procedure. See the following table for examples of how to set this
feature.
Table 2 - Intercharacter Delay Setting Examples
STEP
1 Desired Setting
Divide by 10 (pad with leading
2
zeroes to yield two-digits)
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCHARACTER DELAY SETTING
Scan two characters from
5
Appendix D
6 Scan ENTER/EXIT PROGRAMMING MODE
with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
and scan the bar code: SELECT INTERCHARACTER DELAY SETTING.
page 27
duration which was determined in the steps above. You will hear a two-beep indi-
cation after the last character.
NOTE: If you make a mistake before the last character, scan the CANCEL
bar code to abort and not save the entry string. You can then start again at
the beginning.
ACTION
RS-232/USB COM PARAMETERS
Appendix D
EXAMPLES
50ms 150ms
05 10
'0' and '5' '1' and 5'
PRODUCT REFERENCE GUIDE
, that represent the
600ms 850ms
60 85
'6' and '0' 8' and '5'
225