C-COR Flex Max901e Equipment Manual page 68

Flex Max901e Trunk Amplifier Configured for 870MHz operation with 14.5dB
Output Tilt
5
Figure 5.6
Flex Max901e trunk
amplifier configured
for 870MHz
operation
5-12 Flex Max901e 1GHz Trunk and Bridger Amplifiers
Note The following example is how this Flex Max901e is shipped from the factory.
Note After initial setup, 870 MHz equalizers and cable simulators may be used.
1. Ensure that a GEQC-870-080 (8 dB) or a GEQC-1 GHz-090 (9 dB) is installed in the O/P EQ
location.
2. In the INTERSTAGE PAD location, ensure that:
– an NPB-010 (1 dB PAD) is installed if using GEQC-870-080 in Step 1
– an NPB-000 (0 dB PAD) is installed if using GEQC-1 GHz-090 in Step 1.
3. Ensure that an NPB-020 (2 dB) PAD is installed in the BRIDGER EQ/PAD location.
4. Ensure that an NPB-000 (0 dB) PAD is installed in the P5/P6 FWD PAD locations.
5. Do not remove the jumper installed in the INTERSTAGE EQ location.
NPB-010 if a GEQC-870-080 is installed in O/P EQ
or
NPB-000 if a GEQC-1GHz-090 is installed in O/P EQ
15
AMPS
DANGER
HIGH
PORT 1
VOLTAGE
FWD
PORT 1
I/P TP
STATION
FWD PAD
STATION
FWD EQ
DANGER
HIGH
VOLTAGE
STATION
REV EQ
PORT 2
DISTRIBUTION
PORT 2/3 FWD
PORT 3
O/P TP
DANGER
HIGH
VOLTAGE
15
AMPS
PORT 1 REV
O/P TP EQ
FLEX MAX
MODULE
FM901e AMPLIFIER
INTERSTAGE
HOLD DOWN
PAD
A
SLOT
B
B
SLOT
A
TRANSPONDER
BRIDGER 2
STATION
EQ/PAD
REV PAD
CAUTION
UNPLUG POWER SUPPLY
CONNECTOR BEFORE
REMOVING RF MODULE
POWER
PLUG
MODULE
P5/P6 FWD
HOLD DOWN
PAD
0 JMP
PORT 2/3 REV
I/P TP
NPB-000 PAD
GEQC-870-080
or
GEQC-1GHz-090
15
PORT 4 REV
AMPS
I/P TP
O/P EQ
DANGER
EQ 90
HIGH
PORT 4
MODULE VOLTAGE
FWD
HOLD DOWN
PORT 4
O/P TP
ALC PAD
ALC
ALC DANGER
SENSITIVITY
HIGH
VOLTAGE
MAN
PORT 5
DISTRIBUTION
PORT 5/6 FWD
PORT 6
O/P TP
MODULE
DANGER
HOLD DOWN
HIGH
VOLTAGE
15
PORT 5/6 REV
AMPS
I/P TP
NPB-020 PAD
1502154 Rev D