C-COR Flex Max901e Equipment Manual page 67

Flex Max901e Trunk Amplifier Configured for 1GHz Operation with Equal Output
Tilt on the Trunk and Bridger Legs
1.
2.
3.
4.
Figure 5.5
Flex Max901e trunk
amplifier configured
for 1GHz operation
with equal output tilt
on the trunk and
bridger
1502154 Rev D
Note The following example is how this Flex Max901e is shipped from the factory.
Note This FM901e configuration is suitable for replacement of FNT7, FNT8, FNT9
amplifiers.
Ensure that a GEQC-1GHZ-090 (9 dB) is installed in the O/P EQ location.
(17 dB output tilt. See note below for optional tilts.)
Ensure that an NPB-020 (2 dB) PAD is installed in the BRIDGER EQ/PAD location.
Ensure that an NPB-000 (0 dB) PAD is installed in the INTERSTAGE PAD and P5/P6 FWD
PAD locations.
Do not remove the jumper installed in the INTERSTAGE EQ location.
15
PORT 1 REV
AMPS
O/P TP
MODULE
DANGER
HOLD DOWN
HIGH PORT 1
VOLTAGE
FWD
PORT 1
I/P TP
STATION
FWD PAD
STATION
FWD EQ
DANGER
HIGH
VOLTAGE
STATION
REV EQ
PORT 2
STATION
REV PAD
DISTRIBUTION
PORT 2/3 FWD
PORT 3
O/P TP
MODULE
DANGER
HOLD DOWN
HIGH
VOLTAGE
15
PORT 2/3 REV
AMPS
I/P TP
NPB-000 PAD
Note A GEQC-1GHZ-050 plug-in (14 dB output tilt) and a GEQC-1 GHZ-070 plug-in
(15.5 dB output tilt) are optional and must be ordered separately. Please contact your
C-COR sales professional.
PORT 4 REV
EQ
FLEX MAX
O/P EQ
FM901e AMPLIFIER
INTERSTAGE
EQ 90
PAD
A
SLOT
ALC PAD
B
ALC
B
SLOT
A
MAN
TRANSPONDER
BRIDGER 2
EQ/PAD
CAUTION
UNPLUG POWER SUPPLY
CONNECTOR BEFORE
REMOVING RF MODULE
POWER
PLUG
MODULE
P5/P6 FWD
HOLD DOWN
PAD
0 JMP
PORT 5/6 REV
GEQC-1GHz-090
15
AMPS
I/P TP
DANGER
PORT 4 HIGH
MODULE VOLTAGE
FWD
HOLD DOWN
PORT 4
O/P TP
DANGER
ALC
SENSITIVITY HIGH
VOLTAGE
PORT 5
DISTRIBUTION
PORT 5/6 FWD
PORT 6
O/P TP
DANGER
HIGH
VOLTAGE
15
AMPS
I/P TP
NPB-020 PAD
Configuration
5
5-11