C-COR Flex Max901e Equipment Manual page 140

B
B-30 Flex Max901e 1GHz Trunk and Bridger Amplifiers
Table B.11 Value Max Transponder Specifications
Characteristic
Receiver Specifications
Frequency Range
Frequency Resolution
Modulation Type
Modulation Tolerance
Frequency Deviation
Data Rate
Data Format
Input Levels
Maximum
Nominal
Minimum
Input Return Loss (75 Ohms)
Interference Rejection
Spurious Outputs
Transmitter Specifications
Frequency Range
Tuning Resolution
Frequency Tolerance
Modulation Type
Modulation Tolerance
Frequency Deviation
Data Rate
Data Format
Output Levels
Maximum
Minimum
Output Attenuator
Bandwidth
Output Return Loss (75 Ohms)
Spurious Outputs
Low Frequency Disturbances (LFD),
defined as power supply switching
frequency, etc., below band spurious that
may have harmonics to high frequencies.
Specification
Agile, 48 to 162MHz
0.1MHz steps
FSK
±2kHz
±50kHz or ±67kHz
38.4kbps
asynchronous, NRZ, burst packet
+20dBmV
0dBmV
–20dBmV
14dB, 50 to 1002MHz
±300kHz, 0dB
±600kHz, 20dB
–15 dBmV max., 50 to 1002MHz
Agile, 5 to 21MHz
0.1MHz steps
0.01%, unmodulated mark
FSK
±2kHz
±50kHz or ±67kHz
38.4kb/s
asynchronous, NRZ, burst packet
+40dBmV, ±3dB (0dB attenuation)
+10dBmV, ±3dB (30dB attenuation)
0 to 30dB in 2dB steps, ±1dB
300kHz @ –40dB
500kHz @ –50dB
14dB, 5 to 42MHz
–55dBc max. relative to transponder transmit carrier or
–15dBmV max., 5 to 88MHz (referred to a 6MHz measurement
bandwidth)
<–65dBc with transponder installed.
Note: This is different from single in-band spurious requirement
because these spurs are closely spaced.
1502154 Rev D