Removing The Server Top Cover - Inspur NF5260FM6 User Manual

Figure 4-1 Pulling the Server Out
1
3. After installation or maintenance, push the server into the rack until it is seated
in place.

Removing the Server Top Cover

Do not touch the drive and internal system components before they cool down
to prevent injuries caused by overheating on the server surface.
For proper cooling, do not run the server without the top cover, air directors, or
fans installed. If the server supports hot-swap of components, avoid frequently
opening the top cover of the server.
To remove the component:
1. If you want to perform non-hot-swap installation or maintenance, power off
the server.
2. Pull the server out of the rack.
3. Use a screwdriver to loosen the safety screws on the cover locker.
4. Lift the cover locker handle, as shown by the arrow below, and remove the
server top cover.
2
1
21