Inspur NF5260FM6 User Manual page 11

b. Move the device to a ventilated area to dry the system up. Keep it dry for at
least 24 hours.
c. Close the cover, connect the system's power cable, and power on the
system.
d. If it cannot operate normally, contact Inspur for support.
3. The wiring layout should ensure that the system cables and power cables will
not be stepped on or knocked off. Do not place any objects on the cables.
4. Before removing the chassis cover or touching any inner component, wait until
the device is cooled down. After the system is turned off, wait 5 seconds before
removing components from the mainboard or disconnecting from peripheral
devices to avoid damage to the mainboard.
5. If a modem, or telecom or LAN component is installed:
a. Do not connect or use the modem in the event of lightning to avoid
lighting strikes.
b. Do not connect or use the modem in a humid environment.
c. Do not insert the modem or phone cable into the NIC port.
d. Before unpacking the product, touching or installing inner components, or
touching an uninsulated modem cable or jack, be sure to disconnect the
modem cable.
6. To prevent static discharge from damaging the electronic components inside
the device:
a. Discharge static electricity from your body before installing, removing, or
touching any electronic components inside the device. You can remove the
static electricity from your body by touching a grounded metal object
(such as the unpainted metal surface of the chassis) to and prevent
damage to ESD-sensitive components caused by static discharge.
b. Do not take out ESD-sensitive components from their anti-static packaging
materials if they are not intended for use.
c. Regularly touch grounded conductors or unpainted metal surface of the
chassis during operation to discharge static electricity from your body that
could damage inner components.
7. When installing or removing any components inside the system with the
permission of Inspur:
a. Power off the system and disconnect its power cable and all the cables
connected to the system. Disconnect the cable by holding the cable
connector (instead of the cable) and pulling it out.
3