Inspur NF5260FM6 User Manual page 40

To avoid damage caused by insufficient heat dissipation and high temperature,
make sure that all the trays are equipped with components or blank fillers
before you run the server.
1. Remove the blank fillers.
2. Install the power module in the power connector.
Figure 5-9 Installing the power module
3. Connect the power cable to the power supply.
4. Pass the power cable through the power cable anchor hole or the cable
management arm.
5. Reposition the cable management arm to the work position.
6. Connect the power cable to the power supply.
7. Check whether the power LED is displayed normally.
32