Main Board Jumper & Deep Switch Settings - Vecow ECS-9240-GTX1050T User Manual

2.5 Main Board Jumper & Deep Switch Settings
2.5.1 Top View of ECS-9200/9100 GTX1050 Main Board With Jumper
and DIP Switch
CN25
CN18
SATA2
Mini PCIe 2
Mini PCIe 1
The figure below is the top view of ECS-9200/9100 GTX1050 main board which
is the main board. It shows the location of the jumpers and the switches.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, you connect the pins
with the clip. To "open" a jumper, you remove the clip. Sometimes a jumper will
have three pins, labeled 1, 2 and 3. In this case you would connect either pins 1
and 2, or 2 and 3.
©Vecow ECS-9200/9100 GTX1050 User Manual
JP3 JP4
CN10
JP6
CN9
JP5
JP10
SATA1 J4 FAN1
SODIMM 2 SODIMM 1
J2
JP2 Mini PCIe 3
JP1
CN3
BIOS
JP9
J9 J8 J7
CN6
Battery
J1
GETTING TO KNOW YOUR ECS-9200/9100 GTX1050
J6
FAN2
SW2
M2_CN2
CN15
M2_CN1
38