Table of Contents
Advertisement
2.6 Main Board Jumper & Deep Switch Settings
2.6.1 Top View of ARS-2000 with Jumper and Deep Switch
J3
CN5
CN33
J4
SW2
The figure below is the top view of ARS-2000 board, and it shows the location of
the jumpers and the switches.
You may configure your card to match the needs of your application by setting
jumpers. A jumper is a metal bridge used to close an electric circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that
slides over the pins to connect them. To "close" a jumper, please connect the
pins with the clip. To "open" a jumper, please remove the clip. Sometimes a
jumper will have three pins, labeled 1, 2, and 3. In this case you would connect
either pins 1 and 2, or 2 and 3.
©Vecow ARS-2000 User Manual
JP5
JP11
SODIMM2
SODIMM1
JP3
JP80
USB2_1
JP4
JP1
U4
USB2_2
CN14
GETTING TO KNOW YOUR ARS-2000
J2
CN13
J11
BZ1
J12
BAT
JP2
FAN1
JP8
JP7
J9
JP9
JP6
JCOM3
J10
1
JCOM2
JCOM4
JCOM1
46
Advertisement
Table of Contents
