Front Wheels Toe-In - Check - New Holland Workmaster 25S Operator's Manual

Front wheels toe-in - Check

Front wheel toe-in adjustments were made on your trac-
tor at the factory. Normally, the wheels maintain their
toe-in however, an occasional check should be made.
To check toe-in:
1. With the front wheels in the straight ahead position,
mark the front of the wheels (not the tires) (A) at wheel
hub height.
2. Measure and record the distance between the front of
the wheels at the marks, then push the tractor forward
or backward until the marks are at wheel hub height on
the rear of the wheel.
3. Measure and record the distance between the marks
at the rear of the wheels (B).
4. The difference between the dimensions recorded in
Step 2 and Step 3 should be 0 – 8 mm (0 – 0.31 in)
toe-in. The distance between the marks on the wheels
should be greater at the rear than at the front. Toe in
formula is: B - A = 0 – 8.0 mm (0 – 0.31 in). See your
NEW HOLLAND dealer if your tractor requires adjust-
ment.
7 - MAINTENANCE
7-32
1
NHIL17CT01264AA