New Holland Workmaster 25S Operator's Manual page 136

2. Push the PTO switch (2) down and turn the switch to
the ON position (3).
NOTE: When the PTO is engaged the PTO indicator
light (4) will be illuminated on the instrument panel.
3. To disengage the mid and rear PTO push down on the
PTO switch. The switch will automatically return to the
OFF position.
Stationary rear Power Take-Off (PTO) operation
WARNING
Entanglement hazard!
Before operating stationary Power Take-Off (PTO) equipment, do the following: apply the parking
brake, place all controls in the neutral position, and block all four wheels.
Failure to comply could result in death or serious injury.
NOTE: The engine will shut off in approximately two seconds if the operator leaves the seat without the Hydrostatic
Transmission (HST) pedals not in the neutral position and the PTO shift lever not in the REAR PTO position.
NOTE: The Mid PTO cannot be operated without an operator present in the seat.
Perform the following steps to operate the stationary rear
PTO.
1. You must sit in the operator's seat.
2. Shift the transmission range lever in the neutral posi-
tion.
3. Engage the park brake.
4. Move the PTO shift lever to the rear position.
5. Move the PTO switch to the "ON" position.
6. You will now be able to leave the seat and perform the
stationary rear PTO operation.
7.
To cancel the operation of the stationary rear PTO the
following operations must be performed.
1. Move the PTO switch to the "OFF" position.
6 - WORKING OPERATIONS
6-16
8
NHIL17CT00185AA
W0336A