Starting The Tractor With Jumper Cables - New Holland Workmaster 25S Operator's Manual

Compact tractor, tier 4b (final)
Hide thumbs Also See for Workmaster 25S:
Table of Contents

Advertisement

Starting the tractor with jumper cables

WARNING
Unexpected machine movement!
Always sit in the operator's seat to operate the machine. DO NOT bypass the key start switch. Sudden
and unexpected machine movement or machine runaway could result.
Failure to comply could result in death or serious injury.
WARNING
Explosive gas!
Batteries emit explosive hydrogen gas and other fumes while charging. Ventilate the charging area.
Keep the battery away from sparks, open flames, and other ignition sources. Never charge a frozen
battery.
Failure to comply could result in death or serious injury.
WARNING
Explosion hazard!
When jump-starting the machine, connect and disconnect the jumper cables exactly as indicated in
this manual. DO NOT connect the jumper cables to the machine battery terminals. Make sure no
persons are near the connecting points before starting the engine. Start the engine from the operator's
seat.
Failure to comply could result in death or serious injury.
If you must use jumper cables to start the tractor:
1. Shield your eyes.
2. Connect the red end of the jumper cable to the positive
(+) battery terminal (1) on the tractor and connect the
other red end to the positive (+) battery terminal (2) on
the auxiliary battery.
3. Connect the black end of the jumper cable to the neg-
ative (-) battery terminal (3) on the auxiliary battery,
then connect the other black end to a tractor frame
ground or engine ground (4). Finally, start the tractor
by following the safe starting procedures outlined un-
der See page 4-6 .
4. When the engine starts allow the engine to idle, and
turn on all electrical equipment (lights, etc.) This will
help protect the alternator from possible damage due
to changes in load when disconnecting the jumper ca-
bles.
5. Disconnect the jumper cables in reverse order, discon-
nect the black end from the tractor frame or engine
ground (4) then disconnect the other black end from
the negative (-) battery terminal (3) on the auxiliary bat-
tery.
6. Disconnect the red end from the positive (+) battery
terminal (2) on the auxiliary battery.
7. Remove the other red end from the positive (+) battery
terminal (1) on the tractor battery.
4 - OPERATING INSTRUCTIONS
4-8
W0464A
W0005A
W0342A
1
20100878

Advertisement

Table of Contents
loading

Table of Contents