Hydraulic Oil Suction Filter - Replace - New Holland Workmaster 25S Operator's Manual

Hydraulic oil suction filter - Replace

NOTE: Replace the hydraulic system oil filter after the first 50 hours of operation, and then following every 250 hours
of operation thereafter.
The hydraulic system uses a spin-on type oil filter, lo-
cated on the left side of the tractor between the rear
axle housing and drawbar support. To replace the filter
(1):
1. Unscrew the used oil filter and discard.
2. Coat the gasket on the new filter with a film of clean oil.
Screw the filter into place until the gasket contacts the
sealing surface, then tighten the filter by hand approxi-
mately three-quarters of a turn. Do not overtighten.
3. Start the engine and check the filter for leaks.
4. Stop the engine and check the hydraulic system oil
level. Add oil if necessary.
7 - MAINTENANCE
7-16
1
NHIL17CT01277AA