Front Wheels Toe-In - New Holland WORKMASTER 35 Operator's Manual

6. Push in on the bulb (4) and rotate bulb counter-clock-
wise in socket to remove.
NOTE: Replace with a R10 watt bulb.
7. Insert the new bulb into the socket and turn it clockwise
until the bulb locks into place.
8. Install lenses and retaining screws.

Front wheels toe-in

If toe-in is not correct, adjust as follows:
1. Loosen the tie rod locknuts (1).
2. Adjust the tie rod tube assembly (2) as required to give
0 - 5 mm (0 - 0.2 in) toe-in.
3. After the correct toe-in is obtained, tighten the tie rod
locknuts.
7 - MAINTENANCE
7-44
4
93100886
1
93100867