Fuel Filters - Replace - New Holland Workmaster 25S Operator's Manual

Fuel filters - Replace

CAUTION
Fuel vapors are explosive and flammable.
Do not smoke while handling fuel. Keep fuel away from flames or sparks. Shut off engine and remove
key before servicing. Always work in a well-ventilated area. Clean up spilled fuel immediately.
Failure to comply could result in minor or moderate injury.
Prior operation:
Remove the engine side panel. See page 7-3.
The location of the fuel filter (A) is on the right-hand side of the engine.
1. Close the fuel shut off valve by turning the fuel valve
lever (1) one quarter turn in the clock-wise direction.
2. Place a suitable drain pan below the fuel filter bowl (6).
3. Loosen the metal ring (7) and remove it from the fuel
filter housing.
4. Remove the fuel filter bowl (6).
5. Remove the fuel filter element (2).
6. Install a new fuel filter element.
7. Clean any dirt or water found in the bottom of the fuel
filter bowl. Keep the water indicator ring (4) in the bot-
tom of the fuel filter bowl.
8. Inspect the O-ring (5) and replace if necessary.
9. Install the fuel filter bowl being careful to align the spring
(3) to the bottom of the fuel filter element.
10. Install the metal ring and tighten by hand.
11. Open the fuel shut valve by tuning the fuel valve lever
one quarter turn counter clock-wise.
12. Bleed the fuel injection system as described in 7-39.
7 - MAINTENANCE
1
NHIL17CT01282AA
7-14
C0195A
2
NHIL17CT01381BA