Table of Contents
Advertisement
Hydrostatic Transmission (HST) oil filter - Replace
The Hydrostatic Transmission (HST) system uses a
spin-on type oil filter, located on the right-side of the
tractor underneath the operator's platform.
To replace the filter (1):
1. Unscrew the used oil filter and discard.
2. Coat the gasket on the new filter with a film of clean
oil. Screw the filter into place until the gasket con-
tacts the sealing surface, then tighten the filter by
hand approximately three-quarters of a turn. Do
not overtighten.
3. Start the engine and check the filter for leaks.
4. Stop the engine and check the hydraulic system oil
level. Add oil if necessary.
7 - MAINTENANCE
7-17
1
NHIL17CT01278AA
Advertisement
Table of Contents
Troubleshooting
