Setting The Trigger - Eclipse EGO User Manual

Setting The Trigger

There are three adjustment points on the trigger - the
Screw
As standard each Eclipse Ego comes with a factory-set trigger travel of
approximately 2mm in total length: one millimetre of travel before the
firing point, and one millimetre of travel after the firing point.
The
prior to the marker firing. Turn this screw clockwise to reduce the
amount of travel. Do not turn the screw too far or the trigger will be
pushed past its firing point and the marker will not work. Turn this screw
counter clockwise to increase the amount of trigger travel
The
after the marker has fired. Turn this screw clockwise to reduce the
amount of travel. Do not turn the screw too far or the trigger will be
prevented from reaching its firing point and the marker will not work.
Turn this screw counter clockwise to increase the amount of trigger
travel
The
with which the trigger is returned to its rest position. Turn the screw
clockwise to increase the amount of force
the screw too far or it will negate the position of the Front Stop Trigger
Screw. Turn the screw counter clockwise to reduce the amount of force.
Do not turn the screw too far or there will not be enough force to return
the trigger.
Once you have set the trigger to your preference, refer to setting the
28
BAND (see page 37)
are set up together for the Trigger Transition Filtering to work correctly.
Rear Stop Trigger Screw
, the and the
Front Stop Trigger Screw
is used to set the amount of trigger travel
Rear Stop Trigger Screw
is used to set the amount of trigger travel
(See Figure 4.2)
Return Strength Trigger Screw
is used to adjust the amount of force
, as it is very important that the
Front Stop Trigger
Return Strength Trigger Screw
.
(See Figure 4.1)
(See Figure 4.3)
. Do not turn
TT
TT BAND
and trigger pull
FIGURE 4.1
FIGURE 4.2
FIGURE 4.3