Eclipse EGO User Manual page 50

50
FIGURE 6.52
Assembling the Ego
Having stripped down the Eclipse Ego, here is a guide
FIGURE 6.53
of how best to re-assemble it.
Clean and lubricate the seal at the back of the LPR
body
the Eclipse Ego body, so that the bottom of the LPR
body lines up with the FRM window in the bottom of the
FIGURE 6.54 Eclipse Ego body
Insert the FRM, ensuring that all of the seals are in the
correct place and that the FRM lines up with the bottom
of the LPR body
inch hex key tighten down the FRM retaining screw to
secure both the FRM and LPR in place.
Lubricate the two seals at the front of the rammer
FIGURE 6.55
assembly
valve shaft before inserting exhaust valve into the brass
bushed valve guide
FIGURE 6.56
(See Figure 6.52)
. Slide the entire LPR back into
(See Figure 6.53)
.
(See Figure 6.54)
. Using the 3/16th"
(See Figure 6.55)
and lubricate the exhaust
(See Figure 6.56)
.