Table of Contents
Advertisement
46
Cleaning and Lubricating
the Rammer
FIGURE 6.28
Pull the bolt pin upwards so that it dis-engages the
rammer, allowing the bolt to be removed via the rear of
the Eclipse Ego
Using a 5/32nd" hex key, unscrew and remove the
rammer cap at the rear of the Eclipse Ego
FIGURE 6.29
Raise the front of the Eclipse Ego and tap the Eclipse
Ego onto your hand until the rammer falls into the palm
of your hand
Thoroughly clean the rammer shaft and all of its seals,
paying special attention to the seal on the middle of the
shaft
the condition of the bumper at the rear of the shaft
(See Figure 6.33)
using authentic Eclipse Ego spare parts.
FIGURE 6.30
WARNING:
De-gas
discharging any stored gas in a safe direction,
and remove the barrel and loader to make the
Ego easier to work on.
(See Figure 6.28)
.
(See Figure 6.30)
.
(See Figure 6.31)
, the rear seal
. Replace any worn seals/bumpers
your
marker,
(See Figure 6.29)
.
(See Figure 6.32)
and
Advertisement
Table of Contents
