Eclipse EGO User Manual page 34

Setting the Ball Detection Time
FIGURE 4.13
34
BALL
The parameter defines how long a paintball has to
sit in the breech before it is considered ready to fire.
Filter
Scroll through the Menu until the
displayed.
Ball Detection Time
The current value of the
the right hand side of the display
Select
Press the pushbutton to enter the edit function
and the edit indicators will appear on the display.
Using the Trigger Filtering
The trigger has to be pulled for a specific time in order
for that trigger pull to be accepted as a valid trigger pull.
The Eclipse Ego cannot be fired until it has had a valid
trigger pull.
The trigger then has to be released for a specific time in
order for that release to be accepted as a valid trigger
release. The Eclipse Ego cannot be fired again until it
has first had a valid trigger release (followed, of course,
by another valid trigger pull).
Press and release the
BALL
value in 1-millisecond increments. Press and hold
Raise
the
BALL
parameter is
rapidly.
Press and release the
BALL
value in 1-millisecond increments. Press and hold
is shown on
Lower
the
(See Figure 4.13)
rapidly.
Press
indicators will disappear from the display to indicate that
the value has been accepted. You have now returned to
Filter
the
With the addition of the Trigger Transition software filter
(see page. 36)
has to be pulled for and how long it has to be released
for to maintain high rates of fire whilst eliminating the
risk of 'Trigger Bounce'
Raise
pushbutton to increase the
BALL
pushbutton to increase the
Lower
pushbutton to decrease the
BALL
pushbutton to decrease the
Select BALL
to save the value and the edit
Menu.
, you can minimise the time that the trigger
value more
value more