Eclipse EGO User Manual page 57

Symptom
My trigger is very "Bouncy", how
can I reduce it?
The Break Beam Sensor System
does not appear to be reading
correctly.
The Break Beam Sensor System is
not reading at all.
Two or more balls are being fed into
the breech.
Possible Cause
Increase the trigger transition filter
settings.
Lengthen and strengthen your
trigger pull.
The Break Beam Sensor System
is dirty.
There is a broken wire or contact,
or a short circuit on either of the
breech sensor ribbon cable.
Either sensor is back to front.
If the Eclipse Ego is being used
with a force feed loader, it is
possible that the loader is forcing
balls past the ball detent.
Solution
Check that your trigger pull is within
the limits of your TT BAND setting
and that your TT TOL suits your
current set-up.
Refer to the Advanced Set-up
Section for guidelines of how to
adjust your Ego trigger accordingly.
Keep the break beam sensors
clean to ensure correct readings
(see Maintenance Section).
Check the plug of the cable.
Check for cuts or pinches in the
sensor cables.
Check that sensors face each other
when installed.
Change the rubber finger detent.
57