Table of Contents
Advertisement
How to Strip the Ego
48
WARNING:
De-gas
your marker, discharging any
stored gas in a safe direction,
and remove the barrel and
loader to make the Ego easier
to work on.
Remove the bolt and bolt pin,
disconnect any hosing and unscrew
the inline regulator from the front
bottle mount as detailed above.
Using a 5/64th" hex key remove the
six screw that attach the Eclipse
Ego grips to the Eclipse Ego frame
(See Figure 6.38)
.
Unplug the solenoid and unplug
the break beam sensors from their
ports on the Eclipse Ego printed
(See Figure 6.39)
circuit board
.
Using a 1/8th" hex key undo the
two frame retaining screws
(See Figure 6.40)
and remove the
frame from the Eclipse Ego body,
taking care not to damage any
(See Figure 6.41)
wires
.
Using a 1/8th" hex key loosen the
set screw that retains the frame tag,
and slide the frame tag rearwards
until it is free from the marker body
(See Figure 6.42)
.
Free the hose from the barb fitting
at the rear of the front regulator
mount, using a pick or other
(See Figure 6.43)
suitable implement
Carefully lift the low-pressure hose,
which runs from the rear Eclipse
QEV to the minifold, clear from its
groove in the Eclipse Ego body, so
that the rammer assembly is ready
to be removed from the Eclipse Ego
(See Figure 6.44)
body
.
FIGURE 6.38
FIGURE 6.39
FIGURE 6.40
FIGURE 6.41
.
FIGURE 6.42
FIGURE 6.43
FIGURE 6.44
Advertisement
Table of Contents
