Eclipse EGO User Manual page 52

52
FIGURE 6.63
Assembling the Ego
Carefully thread the solenoid and Break Beam Sensor leads through the
access hole in the top of the grip frame
grip frame to the marker, tightening the grip frame screws using a 1/8th" hex
FIGURE 6.64
(See Figure 6.64)
key
Ensure that the Break Beam Sensor cables lie neatly in the slots provided
for them in the Eclipse Ego grip frame
solenoid and the Break Beam Sensors into their relevant places on the
Eclipse Ego PCB
FIGURE 6.65
securing the six grip screws using a 5/64th" hex key
Screw the inline regulator back into the FRM
any hosing that was disconnected
bolt pin in the designated groove in the rammer.
You have now assembled your Eclipse Ego.
FIGURE 6.66
FIGURE 6.67
(See Figure 6.63)
.
(See Figure 6.65)
(See Figure 6.66)
and re-attach the Eclipse Ego grips by
(See Figure 6.68)
(See Figure 6.69)
FIGURE 6.68
, and reattach the
. Connect the
(See Figure 6.67)
.
and connect
. Replace bolt and locate
FIGURE 6.69