Eclipse EGO User Manual page 27

Adjusting Your Velocity
When using your Eclipse Ego, you may wish to change the velocity at
which your Eclipse Ego is firing. This is done by inserting a 1/8th" hex key
into the adjuster screw at the bottom of your Eclipse Ego Inline regulator
and adjusting it accordingly
clockwise you decrease the output pressure of the inline regulator and
consequently the velocity, by turning the adjuster screw counter clockwise
you increase the output pressure of the inline regulator and consequently
the velocity.
FIGURE 3.10
Note: after each adjustment fire two clearing shots to
gain an accurate velocity reading. Never exceed 300fps.
Adjusting your LPR Pressure
When using your Eclipse Ego, you may wish to change the output pressure
of your LPR. This is easily done by inserting a 5/32nd" inch hex key into the
adjuster screw at the front and adjusting it accordingly
turning the adjuster screw clockwise, you decrease the output pressure of
your LPR and consequently reduce the pressure driving your hammer back
and forth. By turning the adjuster screw counter clockwise, you increase the
output pressure of your LPR and consequently increase the pressure driving
your hammer back and forth.
FIGURE 3.11
Note: turning the adjuster screw out too far will cause it to fall out.
(See Figure 3.10)
. By turning this adjuster screw
(See Figure 3.11)
27
. By