Eclipse EGO User Manual page 16

Setting Up
Before you can begin to use your Eclipse Ego, there are a few necessary
components that are required to enable the Eclipse Ego to function; namely
an air system and a loader of your choice.
Note: The Eclipse Ego cannot be used with Co2, it can only be
Installing a Preset Air System
Every Eclipse Ego comes complete with an Eclipse On/Off Purge System
(OOPS) allowing a preset regulator and tank to be screwed straight in for
immediate use. Before screwing the preset system into the OOPS ensure
that the on/off knob is wound out approximately half way
careful not to unscrew the on/off knob too far as it will come completely out
of the OOPS. If this happens, replace the on/off knob by screwing it back
into the OOPS in a clockwise direction.
Screw the preset air system into the OOPS
screws in all the way and is tight. Slowly turn the on/off knob in a clockwise
direction allowing the OOPS to depress the pin of the preset air system,
causing the Eclipse Ego to become pressurised, providing there is sufficient
air in your tank
to your Eclipse Ego.
Note: When utilising an OOPS on your Eclipse Ego, the Eclipse
Ego will store air in the valve chamber after the OOPS has dumped
the supply in your gas line and inline regulator. Please remember to
16
discharge the stored air in a safe direction as you are unscrewing the
powered by Compressed Air or Nitrogen.
(See Figure 3.2)
(See Figure 3.3)
. You have now installed a preset air system
on/off knob on the OOPS.
(See Figure 3.1)
. Be
so that the bottle
FIGURE 3.1
FIGURE 3.2
FIGURE 3.3