Eclipse EGO User Manual page 49

Using a 1/8th" hex key, remove the
valve plug from the underside of the
(See Figure 6.45)
Eclipse Ego body
Gently slide the rammer assembly
rearwards until the minifold lines up
with the access slot in the bottom
of the Eclipse Ego body. With the
Eclipse Ego upside down and
facing forward, tilt the solenoid and
minifold to the left freeing the right
hand side of the minifold allowing
both the minifold and solenoid to
be freed from the Eclipse Ego body
(See Figure 6.46)
.
Slide the rammer assembly out
of the rear of the Eclipse Ego,
remembering to remove the valve
(See Figure 6.47)
and valve spring
Remove the exhaust valve and
valve spring from the rammer
assembly, and inspect the sealing
face of both the rammer assembly
body and exhaust valve for
any excessive wear or damage
(See Figure 6.48)
. If the exhaust
valve or brass bushed valve guide
is damaged then replace using
authentic Eclipse Ego parts.
FIGURE 6.45
.
FIGURE 6.46
FIGURE 6.47
.
FIGURE 6.48
FIGURE 6.49
FIGURE 6.50
FIGURE 6.51
Taking the Eclipse Ego body, turn
it so that the underside of the front
regulator mount (FRM) is visible,
exposing the retaining screw
(See Figure 6.49)
. Using a 3/16th"
hex key remove the FRM retaining
screw and remove the FRM from
the Eclipse Ego body
(See Figure 6.50)
.
Once the FRM has been removed
the LPR body is exposed through
the bottom of the Eclipse Ego body.
Slide the complete LPR out of the
(See Figure 6.51)
Eclipse Ego body
You have now stripped down your
Eclipse Ego.
49
.