Points - DPS Telecom NetGuardian 832/864A User Manual

User Name
Password
Get Community
Set Community
Unit MAC
Host Name
Enable DHCP
IP Address
Subnet Mask
Gateway
DNS Server 1 and 2
IP Address
Port
Call Unit ID
Play site name instead
of unit id.
DTMF Password
Call Delay
Disable Ring Detect
Server Mode
Server Port
Voice Prompt Delay
9.5

Points

From the Points menu, you can view alarm point settings like the priority of alarm events, the
notification types that have been set, whether a call list has been enabled for that particular point,
whether the alarm can be escalated to other notification paths that have been selected. More detail on
notification in following Section 8.5.
Used to change the username for logging into the unit.
Used to change the password for logging into the unit (case-sensitive).
Community string for SNMP Get requests
Community string for SNMP Set requests
The MAC address of the destination device
Name of Device
Toggles the Dynamic Host Connection Protocol On or Off. When DHCP is
enabled, all addresses will be disabled however.
The IP address of the SiteDialer
Path defining whether your packets should stay on your local network or be
forwarded to the gateway
Default Gateway path
The IP addresses of the domain name servers
NetGuardian Info
The IP address to the NetGuardian unit
The port connection between the NetGuardian and SiteDialer
Call Settings
Display ID for the Unit
Option to display device name rather than Unit ID when calling out
Password set to acknowledge alarms
Timed delay between notifications
If this option is set to "Yes," then call-in access to the SiteDialer is disabled.
Shows whether or not the SiteDialer is configured in server mode
The port on which the SiteDialer will accept alarms when in server mode.
The amount of time unit will wait for input from the user when giving verbal
options over the phone.
Ethernet
27