Ethernet Configuration - DPS Telecom NetGuardian 832/864A User Manual

6.4

Ethernet Configuration

You must assign your SiteDialer appropriate IP, subnet, and gateway information before it can operate in
your LAN/WAN environment and communicate with your NetGuardians.
To assign your SiteDialer's network settings:
Note: The following steps assume you have established a connection with the SiteDialer. If you have
not done so, see the previous sections in this chapter to connect to your SiteDialer either via serial craft
connection or over LAN.
1. When prompted for the password, enter dpstelecom
2. Type C for the C)onfig menu.
3. Type E for E)thernet settings,
4. Configure the Unit IP address, Subnet mask, and Default gateway.
5. ESC to the main menu.
6. When prompted to save your changes, press Y (yes).
7. Press R to reboot the SiteDialer.
Once the unit reboots, you can continue SiteDialer configuration using the SiteDialerEdit application and
access the unit over IP (Telnet TTY or Web Interface).
Configure the Ethernet port parameters
17