Regulatory Information; Fcc Part 15 Class B; Labeling Requirements (Fcc 15.19); Modifications (Fcc 15.21) - Digi Connect ME Hardware Reference Manual

Regulatory information

These products comply with the following standards.

FCC Part 15 Class B

Radio Frequency Interference (RFI) (FCC 15.105)
The Digi Connect ME and Digi Connect Wi-ME embedded modules have been tested and found to
comply with the limits for Class B digital devices pursuant to Part 15 Subpart B, of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential environment. This equipment generates, uses, and can radiate radio frequency energy, and
if not installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
n
Increase the separation between the equipment and the receiver.
n
Connect the equipment into an outlet on a circuit different from that to which the receiver is
n
connected.
Consult the dealer or an experienced radio/TV technician for help.
n

Labeling requirements (FCC 15.19)

This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
If the FCC ID is not visible when installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed module FCC ID. This
exterior label can use wording such as the following: "Contains Transmitter Module FCC ID: MCQ-
50M880/ IC: 1846A-50M880."

Modifications (FCC 15.21)

Changes or modifications to this equipment not expressly approved by Digi may void the user's
authority to operate this equipment.
Digi Connect ME, Wi-ME, ME 9210, Wi-ME 9210 Hardware Reference Manual
66