Checkout Of The Processor - Kodak X-Omat 2000 PROCESSOR Installation Instructions Manual

Checkout of the PROCESSOR

DRYER
TEMPERATURE
CONTROL
KNOB
[8] Wait until the TEMPERATURE READY LIGHT blinks or does not illuminate.
[9] Insert a THERMOMETER into the DEVELOPER TANK on the non-drive side of the PROCESSOR between the
SIDE PLATE of the DEVELOPER RACK and the RACK SUPPORT.
[10] Check that the temperature of the developer is correct for the operating cycle of the PROCESSOR.
7C8771 – 04DEC98
TOP COVER
2 SIDE
PANELS
DIGITAL
TEMPERATURE
DISPLAY
H172_0500ACD
H172_0500AC
Cycle
33.3 0.3 °C (92.0 0.5 °F)
STANDARD
34.4 0.3 °C (94.0 0.5 °F)
RAPID
Setup and Checkout of the PROCESSOR
[1] Start the wash water supply.
Warning
Dangerous Voltage
[2] Energize the PROCESSOR.
[3] Check:
• DEVELOPER and FIXER TANKS are
agitating correctly
• water is flowing into the PROCESSOR
• water or solutions are not leaking
• solution is flowing into the WEIRS
[4] Install:
• 2 SIDE PANELS
• TOP COVER
[5] Check that the RUN/STANDBY SWITCH operates
correctly.
[6] Set the DRYER TEMPERATURE CONTROL
KNOB to the minimum temperature necessary to
provide dry film.
[7] Check for warm air at the EXHAUST.
Insert THERMOMETER
here
Temperature
H172_1006BCB
H172_1006BC
35