Procomp BVD2A Manual page 48

BVD2A
Wake Up on LAN/Ring
If you enable this item, it allows activity on an add-in card in one of the PCI
slots to resume the system from a power-saving mode. It will also wakeup the
system whenever there is traffic on an installed fax/modem or network adapter.
You might have to connect the fax/modem to a mainboard Wake On Modem
connector, and the LAN card to a mainboard Wake On LAN connector, for this
feature to work.
RTC Alarm Resume
When Enabled, two additional lines will be added to the screen Date (of Month)
Alarm; Time (hh:mm:ss) Alarm to let user set the desired date and time. After
power off, the system will automatic power on at the specified date and time.
Primary INTR
This item acts like a master switch for all the interrupt items that follow. If this
item is set to ON, the all the following interrupts can be manually configured to
act as resets for the power saving timeouts. If this item is set to OFF, then all
the following interrupt items cannot be used to reset the power saving
timeouts.
IRQs Activity Monitoring
Press Enter to display the IRQs Activity Monitoring sub-menu.
These interrupt events can act as triggers to reset the power saving timeouts or
other system maintenance tasks. If you set an interrupt event to Primary, any
activity on that interrupt will reset the timeouts that use the primary timer (e.g.
the power saving modes). If you set an interrupt to Secondary, then any activity
on the interrupt will reset those timeouts that use the secondary timer (usually
background maintenance tasks). If you set an interrupt event to Disabled, any
activity on the interrupt will not reset the timeouts.
Default: Disabled
Default: Disabled
Default: ON
~49~