Procomp BVD2A Manual page 41

BVD2A
AGP Driving Control
This item can be used to signal driving current on AGP cards auto or Manual.
Some AGP cards need stronger than normal driving current in order to operate.
We recommend that you set this item to Auto by default.
AGP Driving Value
When the previous item AGP Driving Control is set to manual, you can define
use this item to set the AGP current driving value.
AGP Fast Write
Use this item to set the speed for writing operations over the AGP bus.
Onchip USB
Use this item to enable the onboard USB support.
USB Keyboard Support
If the previous item has been enabled, you can use this item to enable a USB
keyboard to be used through the USB port. You might want to disable this for
security reasons.
CPU to PCI Write Buffer
When this item is enabled, writes from the CPU to the PCI bus are buffered to
compensate for the different speeds of the CPU and PCI buses. Leave this item
at the default value.
PCI Dynamic Bursting
PCI Master 0 WS Write
PCI Delay Transaction
PCI#2 Access #1 Retry
These items determine how the system carries out read/write operations over
the PCI bus. These items are normally optimally determined by the system's
hardware and chipset, so we recommend that you leave these items at the
manufacturers default.
AGP Master 1 WS Write
AGP Master 1 WS Read
These two items determine how the system carries out read/write operations
over the AGP bus. These items are normally optimally determined by the
system's hardware and chipset, so we recommend that you leave these items at
the manufacturers default.
Default: Auto
Default: DA
Default: Disabled
Default: Disabled
Default: Disabled
Default: Enabled
Default: Enabled
Default: Enabled
Default: Enabled
Default: Enabled
Default: Disabled
Default: Disabled
~42~