Installing Accessory Cables - Procomp BVD2A Manual

BVD2A

2.3-1 Installing Accessory Cables

This section describes how to connect the accessory cable that motherboard or
system housing supports. In the case of ATX, there is no need to use a bracket
to extend the connectors to the rear panel, so here we will discuss only the
installation instructions for Floppy, IDE. Power supply and Front Panel
switch/LED cables.
Caution:
!
connecting or disconnecting any bracket or cable.
ATX Power Cable
The 20-pin ATX power cable supports 5V standby current and soft
power-on switch. The soft power switch can be either momentary or toggle
type and must comply with the ATX specification.
Plug in the power cable to the onboard power connector.
Front Panel Switch and LED Cables
Normally, the front-panel housing has a power switch, power LED, reset
switch, suspend switch, speaker, key lock and HDD LED. These accessories
are included in the housing package.
Refer to the 2.3 -1 "PANEL CONNECTORS SETTING" for proper location
of the connector.
Make sure that the power supply is OFF before
~25~