Procomp BVD2A Manual page 44

BVD2A
Note: Set to Auto is not recommended.
Onboard Serial Port 2
User can select serial port IRQ. If set to Auto, system will assign an IRQ for it.
Note: Set to Auto is not recommended.
UART Mode Select
This lets you select the Infrared mode. Choices are Standard, HPIR, and
ASKIR. If you choose BPIR or ASKIR mode, the screen will show another
two lines to let you choose 'IR Function Duplex' (Full or Half) and " RxD TxD
Active" (Hi Lo; Lo Hi; Hi Hi-,Lo Lo).
IR Transmission Delay
This item lets you enable a transmission delay for infrared communication.
Onboard Parallel Port
This item lets you disable the built-in parallel port, or enable it by assigning a
I/0 address and an Interrupt Request Line (IRQ).
Parallel Port Mode
This item defines the operation of the parallel port. As a default it is set to ECP
+ EPP. If you are connected to a parallel device that supports the
higher-performance EPP (enhanced parallel port) or the ECP (extended
capabilities port) make the appropriate changes to this item.
ECP Mode Use DMA
Select a DMA channel for the port. Choices are 3 or 1.
EPP Mode Select
Select EPP mode for the port.
Default: 2F8/IRQ3
Default: Normal
Default: Enabled
Default: 378/IRQ7
Default: ECP+EPP
Default: 3
Default: EPP1.7
~45~