Procomp BVD2A Manual page 34

BVD2A
The documentation provided with the drive may not tell you what value to use
under the MODE heading. If the drive is smaller than 528 MB, set MODE to
Normal. If the drive is larger than 528 MB and it supports Logical Block
Addressing, set MODE to LBA- Most high-capacity drives support Logical
Block Addressing. If you have such a drive, you might be able to configure it
by setting the MODE to Large. If you're not sure which MODE setting is
required for your drive, set MODE to Auto and let the setup utility try to
determine the mode automatically.
Drive A and Drive B
These items define the characteristics of any diskette drive attached to the
system. You can connect one or two diskette drives.
Video
This item defines the video mode of the system. This motherboard has a
built-in VGA graphics system so you must leave this item at the default value.
Halt On
This item defines the operation of the system POST (Power On Self Test)
routine. You can use this item to select which kind of errors in the POST are
sufficient to halt the system.
Base, Extended and
Other Memory
These items show how much memory is available on the system. They are
automatically detected by the system so you cannot manually make changes to
these items.
Default: 1.44M, 3.5 in., None
Default: EGA/VGA
Default: All, But Keyboard
Default: All. But Keyboard
~35~