Procomp BVD2A Manual page 47

BVD2A
MODEM Use IRQ
This item determines the IRQ in which the MODEM can be detected for power
management purposes. Choices are: 3,4,5,7,9, 10,11, or N/A.
Soft-off by PWR-BTTN
Under ACPI (advanced configuration and power interface) the system can be
turned off mechanically (by the power button) or it can do a software power off.
If the system has been turned off by software, the system can be resumed by a
LAN, MODEM or ALARM wake up signal. This item allows you to define a
software power off using the power button. If the value is set to Instant-Off, the
power button will automatically cause a software power off. If the value is set
to Delay 4 Sec. the power button must be held down for a full four seconds to
cause a software power off.
Wake Up Events
Press Enter to display the Wake Up Events sub-menu.
VGA
When the item is enabled, any video active restarts the global timer for standby
mode.
LPT & COM
If the system is "LPT": The system will auto wake up from standby mode or
suspend mode, when the system transfers data by parallel port.
If the system is "COM": The system will auto wake up from standby mode or
suspend mode, when the system transfers data by serial port.
If the system is "LPT/COM": The system will auto wake up from standby
mode or suspend mode, when the system transfers data by parallel port or
serial port.
HDD & FDD
If the item sets "ON", the system will be normal mode from standby mode or
suspend mode, when it is reading the data from hard disk or floppy.
DMA/master
If the item sets "ON", the system will auto wake up from standby mode or
suspend mode, when the DMA is active.
PowerOn by PCI Card
If this item is enabled the system will wake up from standby mode or suspend
mode when activity on a PCI card is detected.
Default: 3
Default: Instant-off
Default: Press Enter
Default: OFF
Default: LPT/COM
Default:ON
Default: OFF
Default: Disabled
~48~